Line Light Installation Steps And Installation Precautions

Line light installation steps

1. Turn off the power switch first, and then use an electric pen to test whether the power grid wires are energized to prevent electric shocks and other dangers.

2. Open a hole in the ceiling installation place where the linear lamp needs to be installed to facilitate the installation of the linear lamp. Determine the position of the light bar, the size of the hole depends on the size of the light bar.

3. When installing, first install the mounting clips on the lamps on both sides. Defend the jams on both sides of the lamps and install the lamps in the square holes.

4. Connect the power cord, cover the wiring cover and tighten with screws. The number of bolts for fixing lamp holders should not be less than the number of fixing holes on the base of the lamp, and the bolt diameter should match the hole diameter; lamps without fixing holes on the base (punch holes during installation), each lamp is used for fixing bolts Or the number of screws should not be less than 3, and the center of gravity of the lamp should be consistent with the center of gravity of the bolts or screws.

5. Put the lamps and fix them. Double-retract and hold the circlips on both sides of the lamp and put them into the ceiling openings, and the inner circlips against the ceiling, press and hold the mask with your hands and push it up and tighten it.

6. Test whether it can be normal.

The above is about the installation steps of the embedded linear lamp. The operation is very simple. Some people worry that it will not be disassembled if it is broken. Next time, I will introduce the method of removing the embedded linear lamp.

Precautions for installation of line lights

1. waterproof Linear lights cannot be directly installed on combustible objects

Some families use painted three-ply plates to line the back of the ceiling lamp in order to be beautiful. In fact, this is very dangerous and must be insulated. If the high temperature part of the surface of the lamp is close to combustible materials, heat insulation or heat dissipation measures must also be taken.

2. Wrap the connecting wire

The two wire ends connected to the line lamp Power Supply line should be in good electrical contact, and they must be wrapped with black tape and kept a certain distance. If possible, try not to put the two wire ends under the same piece of metal to avoid short circuits. , A danger occurs.

3. Check before installing the line lights

(1) The cross-section of the wire core leading to each lamp, the copper core cord is not less than 0.75mm2, otherwise the lead must be replaced.

(2) The connection between the wire and the lamp cap, and the connection of the parallel wire between the lamp caps should be firm, and the electrical contact should be good, so as to avoid the occurrence of sparks between the wire and the terminal due to poor contact, which may cause danger.

4. Pay attention to safety

Teach children not to throw balloons and other objects at the lamps indoors, so as to prevent the decorations hanging on the lamps from falling and hurting people or affecting the decorative effect of the lamps.